Hearth 700x110
top of page
Search

Furnace Won't Turn On? A Clarksville Homeowner's Checklist Before You Call

Oct 26
3 min read

The first cold morning of the season is when most furnaces get their first real test since spring — and it's when the no-heat calls start. Some of those calls turn out to be a five-minute fix the homeowner could have caught. Some are real failures that need a technician. This checklist separates the two, in the order we'd check them ourselves.


Work through these before you call anyone. If you reach the end and the furnace is still silent, that's what we're here for.


1. The Thermostat


It sounds obvious, which is exactly why it's missed. Confirm the thermostat is set to HEAT (not COOL, not OFF), the temperature is set above the current room temperature, and — if it's battery-powered — that the batteries aren't dead. A weak battery is one of the most common causes of a "dead" furnace that isn't dead at all. If you have a heat pump and the thermostat is set to EM HEAT, switch it back to HEAT unless the outdoor unit has actually failed.


2. The Filter


A filter clogged solid after a summer of AC can restrict airflow enough to trip a safety limit switch and shut the furnace down. Pull the filter and hold it up to a light. If you can't see light through it, it isn't passing air either. Replace it — this is maintenance, not a repair, and it prevents the next shutdown too.


3. The Furnace Switch and Breaker


Most furnaces have a wall switch near the unit that looks like a light switch — and gets flipped like one, by accident, all the time. Check it's ON. Then check the breaker panel for a tripped furnace breaker. Reset a tripped breaker once. If it trips again, stop and call — a breaker that won't hold is telling you something.


4. The Gas Supply (Gas Furnaces)


If other gas appliances in the house are also out, the problem is upstream of the furnace. If only the furnace is affected, check that its gas valve is open (handle parallel to the pipe). Never force a valve, and if you smell gas at any point, skip the rest of this list: leave the house and call your gas utility from outside.


5. The Vents and the Outdoor Unit


Walk the house: supply vents open and unblocked by furniture or rugs, return vents clear. For heat pumps, look at the outdoor unit — heavy ice that never melts, or debris banked against it, will stop it heating properly. Light frost that comes and goes is normal defrost behavior; a unit encased in ice is not.


6. The Condensate Line (High-Efficiency Furnaces)


Modern high-efficiency furnaces drain condensation as they run, and a clogged drain can trip a safety switch and stop the furnace cold. If you can see standing water around the unit or a full drain pan, don't keep restarting it — that's a service call.


When to Stop Checking and Call


Call 511 Comfort LLC Heating and Cooling if: the breaker trips twice, you smell gas or burning, the furnace starts and stops every few minutes, it blows cold air in HEAT mode for more than a short warm-up, or you've been through this list and it's still not running. Those are ignition, control, motor, or safety-switch problems — diagnosable, and almost always cheaper caught on a weekday morning than as a midnight failure in January.


511 Comfort LLC Heating and Cooling serves Clarksville, Nashville, Smyrna, Murfreesboro, Hendersonville, Franklin, Brentwood, Mt. Juliet, Goodlettsville, Hermitage, and surrounding communities across Middle Tennessee.


No heat? Call (615) 967-5137 and we'll get it diagnosed.

 
 
 

Comments


bottom of page